Troy-Bilt 13A-344-563 사용자 설명서

8

•

Remove all screws and staples from crate.

•

Holding the sides of the crate firmly, lift the top of 
the crate up and keep it aside. Avoid tire punctures.

•

Remove and discard plastic bag covering the unit.

•

Lift the rear of the mower and clear the bottom of 
the crate. Repeat for the front.

•

Be sure parking brake is disengaged; roll unit out of 
the crate’s way.

•

Remove loose parts from the grass catcher , 
literature bag and/or the crate very carefully. Refer 
to Figure 1. 

1.

Mulching plug & side-discharge chute

2.

Oil drain sleeve

3.

Bumper (optional)

4.

Hitch Plate (optional)

5.

Ignition keys (not shown)

6.

Operator’s manual (not shown) 

NOTE: Reference to RIGHT or LEFT side of the tractor
in this manual is observed from operator’s position.

The battery is located under the hood assembly above
the left rear wheel. Refer to Figure 3 . 

•

To access the battery, lift the hood assembly from 
the left side of the hood only. Stand on the right side 
of the unit and pivot the hood assembly towards 
you until fully opened. See Figure 2 . 

CAUTION: Do not lift the hood assembly by the two
vent openings located behind the seat. 

•

Remove both wing nuts securing the battery and 
cover to the battery hold-down rods. See Figure 3 .

•

Slide the battery cover towards the rear to access 
the front (negative) terminal.

•

Remove the screw and nut from the negative 
terminal with a wrench. 

•

Attach the black battery cable to this negative 
terminal on the battery and tighten securely. See 
Figure 3 .

WARNING:  Be careful not  to contact any
adjacent metal part or short across posts. 

•

Move the battery cover to its original position. Make 
sure to tuck away the battery cables completely 
under the battery cover. Check to ensure that the 
cables pass easily through the slots in the cover.

•

Reinstall wing nut on the front battery hold-down 
rod and tighten.

•

Place your right hand on the left side of the seat and 
slowly lower the hood assembly until it is fully closed. 

WARNING:  Keep battery cables away from
the engine exhaust system. 

CAUTION: Do not place your hand around the bottom
edge of the hood assembly; it may get pinched between
the hood assembly and grass catcher or the frame rail.

WARNING:  Battery posts, terminals and
related accessories contain lead and lead
compounds. Wash hands after handling.

Your riding mower is shipped to you with the grass
catcher fully assembled on the unit. A side-discharge
chute and a mulching plug are included as loose parts.
Follow the instructions below to attach the side-
discharge chute.