Troy-Bilt ZT42 사용자 설명서

P

P

P

P

P

P

P

P

P

Before performing any maintenance or 

repairs, disengage the PTO, move the drive control 

levers fully outward in the neutral position, engage 

the parking brake, stop the engine and remove the 

key to prevent unintended starting.

Refer to the Kohler Owner’s Manual for all engine maintenance 

intervals, procedures, specifications and instructions.

Locate the oil drain port on the left side of the engine.

1. 

Pop open the protective cap on the end of the oil drain 

2. 

valve to expose the drain port. Refer to Figure 6-1. Remove 

the oil fill cap/dipstick from the oil fill tube.

Push the oil drain hose (packed with this manual) onto the 

3. 

oil drain port. Route the opposite end of the hose into an 

appropriate oil collection container with at least a 2.0 quart 

capacity, to collect the used oil.
Turn the oil drain valve 

4. 

1⁄4-turn, then pull outward to begin 

draining oil. After the oil has finished draining, push the 

end of the oil drain valve back in and turn 1⁄4-turn to secure 

it back in place. Re-cap the end of the oil drain valve to 

keep debris from entering the drain port.
After the oil has finished draining, push the end of the oil 

6. 

drain valve back in, until the tabs click into place. Re-cap 

the end of the oil drain valve to keep debris from entering 

the drain port and refer to the Engine Operator’s Manual 

for refilling instructions, oil type and amount.

NOTE: Maintenance, repair, or replacement of the emission control 

devices and systems which are being done at owner’s expense may 

be performed by any engine repair establishment or individual. 

Warranty repairs must be performed by a Troy-Bilt Dealer.

The zero turn tractor is equipped with dual integrated 

hydrostatic pumps/transaxles that are sealed and are 

maintenance-free. Fluid levels cannot be checked and fluid 

cannot be added or changed.