Multiquip hda-series 사용자 설명서

Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components.  Instruction sheet P/N 20485 provides further details
for the handle assembly.

1.

Install the 

handle tube to the gearbox as shown in (Figure 5).

The mounting hardware should be contained in the shipping
container.

The Quick-Pitch™ handle is spring loaded,
personal injury or damage could result from

improper handling or installation. Be careful
when installing this component.

2.

On Quick-Pitch™ models, pivot the 

 Handle

back (full pitch),  (Figure 6). This will relax the spring inside
the handle tube. On either  model, spread the handle bar
ends just enough to engage the teeth on the handle tube.
Attach the hand wheel assembly, position handlebar to
desired location, and tighten hand wheel firmly.

2. Feed the throttle cable through the cable housing.

3. Connect the throttle cable to the engine (Figure 8).  There

should be a piece of wire installed on the trowel to show
where to route the throttle cable. When connecting the cable
housing, make sure that no more than 

1/4" (6.4mm) of the

cable housing protrudes past the housing clamp on the
engine.

1.

Place the throttle lever (Figure 7) to the idle position.

Considerable force may be
required when moving the Quick-
Pitch

  Handle forward or

backward.

 NOTE