Poulan 178493 사용자 설명서
20
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•
•
Depress clutch/brake pedal fully and set parking brake.
•
Place motion control lever in neutral (N) position.
•
Place attachment clutch in “DISENGAGED” position.
•
Turn ignition key “OFF” and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
plug.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See “PROD-
driveway. Make sure tires are properly inflated (See “PROD-
BOTTOM EDGE OF
MOWER TO
GROUND
MOWER TO
GROUND
FIG. 20
BOTTOM EDGE OF
MOWER TO
GROUND
A
A
GROUND LINE
TRACTOR
TO REMOVE MOWER (See Fig. 19)
•
Place attachment clutch in “DISENGAGED” position.
•
If equipped, turn height adjustment knob to lowest
setting.
setting.
•
Lower mower to its lowest position.
•
Remove retainer spring holding anti-swaybar to chassis
bracket and disengage anti-swaybar from bracket.
bracket and disengage anti-swaybar from bracket.
•
Remove four retainer springs from front plate assembly
and remove plate.
and remove plate.
•
Remove retainer springs from suspension arms at deck
and disengage arms from deck.
and disengage arms from deck.
•
Raise attachment lift to its highest position.
•
Slide mower forward and remove belt from electric
clutch pulley.
clutch pulley.
•
Slide mower out from under right side of tractor.
TO INSTALL MOWER
Follow procedure described in “INSTALL MOWER AND
DRIVE BELT” in the Assembly section of this manual.
DRIVE BELT” in the Assembly section of this manual.
FIG. 19
UCT SPECIFICATIONS” section of this manual). If tires are
over or underinflated, you will not properly adjust your
mower.
over or underinflated, you will not properly adjust your
mower.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)
•
•
Raise mower to its highest position.
•
Measure height from bottom edge of mower to ground
level at front corners of mower. Distance “A” on both
sides of mower should be the same.
level at front corners of mower. Distance “A” on both
sides of mower should be the same.
•
If adjustment is necessary, make adjustment on one
side of mower only.
side of mower only.
•
To raise one side of mower, tighten lift link adjustment
nut on that side.
nut on that side.
•
To lower one side of mower, loosen lift link adjustment
nut on that side.
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 3/16".
•
height about 3/16".
•
Recheck measurements after adjusting.
FRONT
PLATE
ASSMEBLY
PLATE
ASSMEBLY
RETAINER
SPRINGS
SPRINGS
LIFT
LINKS
LINKS
RETAINER
SPRING
SPRING
ADJUSTMENT
NUTS
NUTS
SUSPENSION
ARMS
ARMS
CHASSIS
BRACKET
BRACKET
FRONT MOWER
BRACKET
BRACKET
ELECTRIC
CLUTCH
PULLEY
CLUTCH
PULLEY
ANTI-SWAY
BAR
BAR
RETAINER
SPRINGS
SPRINGS
FRONT
MOWER
BRACKET
MOWER
BRACKET