McCulloch M13538 사용자 설명서

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.

(1) 1/2"  wrench Utility knife

(1)  3/4" wrench Tire pres sure gauge

Pliers

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

•  Remove all accessible loose parts and parts cartons  

from carton.

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Check for any additional loose parts or cartons and 

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 

the correct tools as necessary to insure proper tightness.

•  Slide extension shaft onto lower steering shaft.  
•  Place tabs of steering boot over tab slots in dash and 

push down to secure.

02825

246

6

02464

Adjust seat before tightening adjustment knob.
•  Remove adjustment knob and flat washer securing 

seat to cardboard packing and set aside for assembly 

of seat to tractor.

• 

Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

• 

Position front wheels of the tractor so they are pointing 

straight forward.

•  Remove steering wheel adapter from steering wheel 

and slide adapter onto steer ing shaft ex ten sion.

•  Position steering wheel so cross bars are hor i zon tal 

(left to right) and slide inside boot and onto adapt er.

• 

Assemble large flat washer, 5/16 lock washer, 5/16 hex 

bolt and tighten se cure ly.

• 

Snap steering wheel insert into center of steer ing wheel.

• 

Remove protective materials from trac tor hood and grill.

•   Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•   Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•   Pivot seat and pan forward and assemble adjustment 

knob and flat washer loosely. Do not tighten.

  

Lower seat into operating position and sit on seat.

• 

Slide seat until a comfortable position is reached which 

allows you to press clutch/brake pedal all the way down.

•  Get off seat without moving its ad just ed position.
•  Raise seat and tighten adjustment knob securely.