Great Dane GDRZ48-19KAE 사용자 설명서

Operating - 13

OPERATING

MX13149

2. Move the mower deck lift lever (A) to the transport
position (D).

3. Position the HOC adjustment pin (C) in the proper hole
for the desired height-of-cut.

4. Pull back and hold the mower deck lift lever (A) and
release the transport position lock lever (B).

MX13155

5. Allow the mower deck lift lever (A) to rest against the
HOC adjustment pin (C).

Adjusting Mower Deck Anti-Scalp Wheels

NOTE: The flattest cut can be achieved by having all
anti-scalp wheels adjusted off the ground. Check anti-
scalp wheel adjustments each time the mower deck
cutting height is changed.

It is recommended that all anti-scalp wheels be kept off
the ground to minimize scuffing.

1. Inflate tires to correct pressure.

2. Adjust mower deck to desired cutting height.

NOTE: The rear anti-scalp wheels are located under the
rear of the mower deck.

MX15281

3. Adjust anti-scalp wheel (A) to one of two positions (B).

•

Remove screw (C), nut and washer.

•

Adjust wheel up or down so it is approximately 6-13

mm (1/4-1/2 in.) above mowing surface.

4. Install wheel with attaching hardware.

5. Adjust all wheels to same height.

Using the Park Brake

Locking Park Brake:

CAUTION: Avoid injury! Fingers or loose

clothing can get caught in rotating parts. Stop
engine and wait for all moving parts to stop
before servicing.

CAUTION: Avoid injury! Children or bystanders

may attempt to move or operate an unattended
machine.

Always lock the park brake and remove the
key before leaving the machine unattended.

CAUTION: Avoid injury! If the engine should

stop while operating on an incline, the mower
will free-wheel. If this should occur, lock the
park brake, start the engine, unlock the park
brake and resume operation.