Gravely 915168 - ZT34 CARB 사용자 설명서
EN - 11
Stop and inspect equipment if you strike an
object or if there is an unusual vibration.
Repair, if necessary, before restarting. Never
make adjustments or repairs with the engine
running.
object or if there is an unusual vibration.
Repair, if necessary, before restarting. Never
make adjustments or repairs with the engine
running.
Mower blades are sharp and can cut you.
Wrap the blade(s) or wear gloves, and use
extra caution when servicing them. NEVER
weld or straighten mower blades.
Wrap the blade(s) or wear gloves, and use
extra caution when servicing them. NEVER
weld or straighten mower blades.
Rotation of one blade may cause rotation of
the other blades.
Check brake operation frequently. Adjust and
service as required.
the other blades.
Check brake operation frequently. Adjust and
service as required.
Keep all hardware properly tightened.
Stored energy in springs can cause injury.
Maintain or replace safety and instruction
labels, as necessary.
Maintain or replace safety and instruction
labels, as necessary.
Never store the machine or fuel container
inside a building where there is an open
flame, such as a water heater.
inside a building where there is an open
flame, such as a water heater.
Shut off fuel (if provided) and allow engine to
cool completely before storing in closed area
or covering unit.
cool completely before storing in closed area
or covering unit.
Clean grass and debris from unit, especially
from around muffler and engine, to help
prevent fires.
For extended storage, clean unit thoroughly.
See storage section and Engine Manual for
proper storage.
from around muffler and engine, to help
prevent fires.
For extended storage, clean unit thoroughly.
See storage section and Engine Manual for
proper storage.
Use only attachments or accessories
designed for your unit.
designed for your unit.
Check attachment components frequently. If
worn or damaged, replace with
manufacturer’s recommended parts.
worn or damaged, replace with
manufacturer’s recommended parts.
Tools Required
•
Adjustable wrench
•
Petroleum jelly or dielectric grease
Unpack Unit
Remove unit and all other components from
the shipping container. Engage transmission
bypass lever. See “MOVING UNIT
MANUALLY” on page 19. Push unit from
container onto a level surface. Disengage
transmission bypass lever.
the shipping container. Engage transmission
bypass lever. See “MOVING UNIT
MANUALLY” on page 19. Push unit from
container onto a level surface. Disengage
transmission bypass lever.
Connect Battery
See "Install Factory-Installed Battery" on
page 26 and perform steps 5 and 6 in the
installation section.
page 26 and perform steps 5 and 6 in the
installation section.
Place Unit in Operating Position
NOTE: The seat is shipped with the seat
positioned as far back as possible.
positioned as far back as possible.
1. Push steering levers aside and tip seat
up.
2. Adjust the seat as needed. See “Seat
3. Remove hardware from top hole of the
steering lever (Figure 3). Slide steering
lever back to align slot with hole at the
top of the steering pivot arm.
lever back to align slot with hole at the
top of the steering pivot arm.
NOTE: Do not tighten hardware before
reviewing See “ADJUSTING STEERING
LEVERS” on page 28. If no adjustment is
desired tighten hardware.
reviewing See “ADJUSTING STEERING
LEVERS” on page 28. If no adjustment is
desired tighten hardware.
Check Engine Oil Level
Refer to Engine Manual.
ASSEMBLY
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
Read and understand the entire
Safety section before proceeding.
Figure 3
1. Steering Lever
2. Steering Pivot Arm
3. Steering Lever Hardware
2. Steering Pivot Arm
3. Steering Lever Hardware