John Deere pd54 사용자 설명서

- 42 -

1. Connect booster battery or batteries to

produce the required system voltage for your

engine application.

NOTE:  To avoid sparks, DO NOT allow the free ends

of jumper cables to touch the engine.

2. Connect one end of jumper cable to the POSITIVE

(+) post of the booster battery.

3. Connect one end of jumper cable to the POSITIVE

(+) post of the battery connected to starter.

4. Connect one end of the other jumper cable to the

NEGATIVE (-) post of the booster battery.

5. ALWAYS complete the hook-up by making the last

connection of the NEGATIVE (-) cable to a good

ground on the engine frame and away from the

battery(ies).

6. Start the engine.  Disconnect jumper cables

immediately after engine starts.  Disconnect

NEGATIVE (-) cable first.

Remove and clean every 600 hours or 12 months.  If

you operate the engine in dusty conditions, clean the

tube at shorter intervals.

1. Remove and clean crankcase vent tube.

2. Install the vent tube.  Be sure the O-ring fits

correctly in the rocker arm cover for elbow adapter.

Tighten hose clamp securely.

Check/adjust at 900 hours then every 1200 hours or 24

months.  See authorized engine service dealer or refer

to Engine Manual for procedures.

Do not adjust operating speed.  Full speed is factory set

at 2500 rpm.

Do not adjust idle speed above 1400 rpm.  Proper idle

rpm is 1200 + 100.

Do not alter injection pumps.

Deere will reissue emissions dataplates only to replace

damaged plates.  Requests must be in writing and

include name, address, engine model, and serial

number with reason for need.

Power rating changes WILL NOT be allowed on new

engines.