Kenmore 3 사용자 설명서

MAINTENANCE
Main Jackshaft Bearing replacement.

IMPORTANT
The Bearing Shims must be replaced exactly as

removed, if the Jackshaft Bearings are removed.

Fig.38
If the Jackshaft Bearings are replaced, the Jackshafts
alignment must be checked and re-set.
The shafts are aligned, fore and aft, with Shims behind the
bearings, and vertically with slotted holes in the bearing
flanges.

• Assemble the Shafts, Sheaves and Bearings with

Lock Collars, and Shims in place as removed.

• Tighten the Bearing Bolts, and with a Straight

Edge across the front of the Shafts, check the ‘fore
and aft’ alignment.

    Add or remove Shims as necessary.
•  Place the Straight Edge on top of the Shafts.
    Back-off the Bearing Bolts and adjust the Bearings

‘up or down’ to align the shafts.

PTO SHAFT SET- UP

Fig.39
The Inner and Outer PTO Shafts are ‘keyed’ to the
Jackshafts. If the Bearings are replaced the shafts the
shafts must be set-up as illustrated.

Fig.38

Fig.39