Yard Machines 840 Thru 849 사용자 설명서
8
SECTION 4: UNPACKING
TO REMOVE UNIT FROM CRATE
•
Remove all screws from the top of the crate using a
1/4" hex head socket or a flat blade screwdriver.
1/4" hex head socket or a flat blade screwdriver.
•
To remove ends, grasp top board on the end, and
pull towards you in a downward motion.
(A hammer may be helpful).
pull towards you in a downward motion.
(A hammer may be helpful).
•
Set panel aside to avoid tire punctures.
•
Repeat procedure for each side of the crate.
•
Remove and discard plastic bag which covers unit.
•
Loose parts (may include the operator’s manual,
steering wheel, battery fluid, chute deflector, etc.)
are on the seat or in a box and wrapped in plastic.
Carefully cut and remove the plastic wrap. Remove
loose parts from the seat.
steering wheel, battery fluid, chute deflector, etc.)
are on the seat or in a box and wrapped in plastic.
Carefully cut and remove the plastic wrap. Remove
loose parts from the seat.
•
Remove the deck from beneath the tractor. Make
certain parking brake is released and unit is in
neutral. See the controls section of this manual for
location of the parking brake release and the shift
lever. Push unit off of the skid.
certain parking brake is released and unit is in
neutral. See the controls section of this manual for
location of the parking brake release and the shift
lever. Push unit off of the skid.
•
Remove page seven from this manual and lay out
the contents of the hardware pack according to the
illustration for identification.
the contents of the hardware pack according to the
illustration for identification.
SECTION 5: ASSEMBLING YOUR GARDEN TRACTOR
IMPORTANT:
After assembly, service engine with
gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
separate engine manual packed with your unit.
NOTE: Reference to right or left hand side of the unit is
observed from the driver’s seat, facing forward.
observed from the driver’s seat, facing forward.
TOOLS REQUIRED FOR ASSEMBLY
(1) 1/4" socket wrench or flat blade screwdriver
(1) 1/2" wrench or socket wrench*
(1) 9/16" wrench or socket wrench
(2) 7/16" wrenches or socket wrenches
*If your steering wheel cap is square, you must have a
socket wrench in order to install the steering wheel.
(1) 1/2" wrench or socket wrench*
(1) 9/16" wrench or socket wrench
(2) 7/16" wrenches or socket wrenches
*If your steering wheel cap is square, you must have a
socket wrench in order to install the steering wheel.
BATTERY INFORMATION
•
Battery acid must be handled with great care as
contact with it can burn and blister the skin. It is also
advisable to wear protective clothing (goggles,
rubber gloves and apron) when working with it.
contact with it can burn and blister the skin. It is also
advisable to wear protective clothing (goggles,
rubber gloves and apron) when working with it.
•
Should battery acid accidentally splatter into the
eyes or onto the face, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical attention.
eyes or onto the face, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical attention.
•
If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of ammonia/
water or baking soda/water.
water, then neutralize with a solution of ammonia/
water or baking soda/water.
•
Since battery acid is corrosive, do not pour it into
any sink or drain. Before discarding empty
electrolyte containers, rinse them with a
neutralizing solution.
any sink or drain. Before discarding empty
electrolyte containers, rinse them with a
neutralizing solution.
•
NEVER connect or disconnect charger clips to
battery while charger is turned on as it can cause
sparks.
battery while charger is turned on as it can cause
sparks.
•
Keep all lighted materials (cigarettes, matches,
lighters) away from the battery as the hydrogen gas
generated during charging can be combustible.
lighters) away from the battery as the hydrogen gas
generated during charging can be combustible.
•
As a further precaution, only charge the battery in a
well-ventilated area.
well-ventilated area.
*Always shield eyes, protect skin and clothing
when working near batteries.
WARNING
Battery contains sulfuric acid. Refer to warning
at right. Antidote: EXTERNAL—Flush with water.
INTERNAL—Drink large quantities of water or milk.
Follow with milk of magnesia, beaten eggs or
vegetable oil. Call physician immediately. EYES:
Flush with cool water for at least 15 minutes, then
get prompt medical attention.
Since batteries produce explosive gases, keep
all lighted materials (cigarettes, lighters,
matches, etc.) away. Be sure to charge battery
only in well-ventilated areas. Make certain venting
path of battery drain tube (if equipped) is always
open.
at right. Antidote: EXTERNAL—Flush with water.
INTERNAL—Drink large quantities of water or milk.
Follow with milk of magnesia, beaten eggs or
vegetable oil. Call physician immediately. EYES:
Flush with cool water for at least 15 minutes, then
get prompt medical attention.
Since batteries produce explosive gases, keep
all lighted materials (cigarettes, lighters,
matches, etc.) away. Be sure to charge battery
only in well-ventilated areas. Make certain venting
path of battery drain tube (if equipped) is always
open.
KEEP BATTERIES
OUT OF THE REACH OF CHILDREN!
DANGER