Dixon 700 Series 사용자 설명서

12. Clean the air intake screen on the

engine if necessary.

13. Perform any other maintenance as it

becomes necessary. (See the

"Maintenance" section of this manual.)

IMPORTANT: Before cutting grass, clutch must be

broken-in as follows: With engine at full

RPM engage deck until blades come to full

speed and then disengage until blades

come to a complete stop. Repeat 10 times

to seat clutch properly.

OPERATION

1. MOVE STEERING CONTROL LEVERS TO

neutral "OUT position.

2. SET PARKING BRAKE. Pull up to set.

3. DISENGAGE MOWER BLADE CLUTCH by

moving clutch switch to "OFF" position.

4. PULL ENGINE CHOKE CONTROL to full

position for cold starts.

5. SET ENGINE THROTTLE TO 1/2

THROTTLE.

6. TURN IGNITION KEY to "START' position and

release to "RUN" as soon as engine starts.
NOTE: Prolonged cranking will damage
starter motor and shorten the battery life.

7. ADJUST ENGINE THROTTLE AND

CHOKE for desired engine smoothness and

speed.

NOTE: When mowing, always run engine at

full throttle.

8. RELEASE PARKING BRAKE. Push brake

lever down to release.

10. TO DRIVE: Move the Steering Control

Levers to the "IN" position. Move the

Steering Control Levers forward to move

forward. Increasing forward movement of

the Steering Control Levers will increase

the speed of travel. To reverse the

direction, pull the Steering Control Levers

slightly back. To turn, move one Steering

Control Lever slightly ahead of the other.

To turn on a zero radius axis, go slowly

and move one Steering Control Lever

forward and one Steering Control lever

rearward. (For a right hand turn the left

hand Steering Control lever will be ahead

of the right hand Steering Control. For a

left hand turn the right hand Steering

control will be ahead of the left hand

Steering Control.)

P-11408 (2/99)