Jacuzzi HE97000 사용자 설명서

Comfort Whirlpool Bath

Installation and Operation 

www.jacuzzi.com

 

Page 13

  Before you begin your installation, please read the following:

• 

Observe all local and building codes.

• 

Determine which tools will be used during the installation.

• 

Additional bathtub drain parts and plumbing are commercially available at plumbing and hardware stores.

• 

Drain/Overflow rough-in information is included with your bathtub in the installation instruction manual.

Flashing

Exploded View

1˝ x 4˝ 

(25mm x 101mm)

Not For Support

Mortar or 

Adhesive

Subfloor 

Sealant

Tile

Complete the bathtub surround installation.

  Install drain/overflow according to the 

manufacturer’s instructions. Refer also to the 

Technical Specifications Manual.

  Watertight installation of the drain is the installer’s 

responsibility. Drain leakage is excluded from the 

Jacuzzi Luxury Bath warranty of this product.

  Install the faucet at this time. It is recommended 

that the faucet be installed by a qualified plumber.

  Proper installation of the spout plumbing and 

compliance with local codes are the responsibility of 

the installer. Jacuzzi Luxury Bath does not warrant 

connections of water supply fittings and piping, 

fill systems, or drain/overflow systems. Nor is it 

responsible for damage to the bathtub which may 

occur during installation.

  A non-flammable protective barrier must be placed 

between the soldering work and the bathtub unit to 

prevent damage to the bathtub.

  Prepare the cut-out hole for the bathtub using 

either the provided full scale template or the cutout 

dimensions listed in the specifications table in the 

Technical Specifications Manual.

  The template may show guides for more than one 

bathtub, be certain to select the appropriate guide 

lines. If under mounting is an option, be careful to 

select the guide lines that apply to the installation 

that you are performing.

  Complete all deck finish work and cover to protect 

from damaging while placing the bathtub.

  Insulation may be placed within the bathtub 

surround.

  Provide adequate ventilation around the motor/

pump to ensure sufficient airflow and cooling.

  Turn off power supply to dedicated GFCI protected 

circuits.

  Place a piece of scrap lumber on each of the ends 

of the cutout – this will be used as a temporary 

support prior to lowering the bathtub fully into the 

opening. 

Tile or Finished 

Surface

Substrate

Scrap Lumber

Support  

Member

Level Subfloor

Scrap Lumber

Minimum 3˝ 

(76mm) 

Clearance