Campbell Hausfeld pw1750 사용자 설명서

When using this product, basic
precautions should always be followed,
including the following:

1.

Read all instructions before using the 
product.

2.

ALWAYS disconnect power before 
disassembling or repairing the unit.

3.

Follow all safety codes as well as the 
Occupational Safety and Health Act 
(OSHA).

4.

Ensure safety devices are operating 
properly before each use. DO NOT
remove or modify any part of the gun 
or unit.

5.

Know how to stop this product and 
bleed pressure quickly. Be thoroughly 
familiar with the controls.

6.

Stay alert – watch what you are doing.

7.

Do not operate the product when 
fatigued or under the influence of 
alcohol or drugs.

8.

Keep operation area clear of all 
persons.

9.

Do not overreach or stand on 
unstable support. Keep good footing 
and balance at all times.

10. Follow the maintenance instructions 

specified in the manual.

11. This product is provided with a ground

fault circuit interrupter, GFCI, be sure 
to inspect cord and GFCI prior to use. 
Any repair or replacement of the 
power cord must be performed by a 
qualified (licensed or certified) 
electrical technician.

12. Never use an extension cord with this 

product.

This pressure washer is equipped with a
microswitch sensitive to water flow. This
Instant Start/Stop switch (ISS) senses
water flow in the pump. When the trig-
ger is released, water stops flowing
through the pump. The ISS then auto-
matically turns the motor off to protect
pump from overheating.

OPERATION
1. Pull trigger on gun.

2. Turn the “ON/OFF” switch to “ON”.

3. Release trigger. The pressure washer

motor will stop running.

4. To spray again, pull trigger and motor

and pump will restart.

Note: Occasionally the motor may run
for a short time to bring fresh, cool
water into the pump even if trigger is
released. This is part of normal opera-
tion and will not damage the unit.