Black Box MPSH16-D20-120V 사용자 설명서

 

5.  Configuration

This section describes the basic configuration procedure for all Outlet Managed PDU 

models.  For more information on Reboot Options and Alarm Configuration, please 

refer to Section 6 and Section 7.

5.1. 

Communicating with the Outlet Managed PDU

In order to configure the Outlet Managed PDU, you must first connect to the unit, 

and access command mode.  Note that, the Outlet Managed PDU offers two separate 

configuration interfaces; the Web Browser Interface and the Text Interface.

In addition, the Outlet Managed PDU also offers three different methods for 

accessing command mode; via network, via external modem, or via local console.  

The Web Browser interface is only available via network, and the Text Interface is 

available via network (SSH or Telnet), modem or local PC.

5.1.1.  The Text Interface
The Text Interface consists of a series of simple ASCII text menus, which allow you 

to select options and define parameters by entering the number for the desired option 

using your keyboard, and then typing in the value for that option.

Since the Web Browser Interface and Telnet accessibility are both disabled in 

the default state, you will need to use the Text Interface to contact the Outlet 

Managed PDU via Local PC or SSH connection when setting up the unit for the 

first time.  After you have accessed command mode using the Text Interface, you 

can then enable Web Access and Telnet Access, if desired, in order to allow future 

communication with the unit via Web Browser or Telnet.  You will not be able to 

contact the unit via Web Browser or Telnet until you have enabled these options.

Once Telnet Access is enabled, you will then be able to use the Text Interface to 

communicate with the Outlet Managed PDU via local PC, Telnet or SSH connection.  

You can also use the Text Interface to access command mode via an external modem 

installed at the Outlet Managed PDU’s serial Setup Port.