DeVillbiss Air Power Company A16091 사용자 설명서

다운로드
페이지 60
16- ENG 
A16091
ENGINE
Consult the Engine Owners Manual for 
the manufacturer's recommendations 
for storage.
PUMP 
The manufacturer recommends using 
a pump protector/winterizer, such as 
DP80, when storing the unit for more 
than 30 days and/or when freezing 
temperatures are expected. If a pump 
protector/winterizer is not available, 
RV antifreeze or windshield washer 
fluid needs to be run through the 
pump as outlined in the steps below.
NOTE: Using a pump protector/ 
winterizer, RV antifreeze or windshield 
washer fluid is to provide proper 
lubrication to the internal seals of the 
pump regardless of temperature or 
environment.
1.   Obtain a funnel, 6 oz. of RV 
antifreeze or windshield washer 
fluid, and 16–36" of garden hose 
with a male hose connector 
attached to one end.
 
Risk of property 
damage. Use only 
RV antifreeze. Any other an ti freeze is 
corrosive and can damage pump.
2. 
Disconnect spark plug wire.
3.   Connect length of garden hose 
to water inlet of pump.
4. 
Add RV antifreeze or windshield 
washer fluid to hose as shown.
5.   Pull engine starter rope slowly 
several times until antifreeze/
washer fluid comes out of high-
pressure hose con nec tion of 
pump.
6.   Remove garden hose from water 
inlet of pump.
7.   Reconnect spark plug wire.
PRESSURE WASHER
1.   Drain all water from high pressure 
hose, coil it, and  store it in cradle 
of the pressure washer handle.
2.  Drain all water from spray gun 
and wand by holding spray gun 
in a vertical position with nozzle 
end pointing down and squeezing 
trigger. Store in gun holder.
3.  Store chemical hose so it is 
protected from dam age.
4.   If space is needed, remove 
handles and replace as shown.
STORAGE