American Standard 3838Y1.SR-NEO.XXX 사용자 설명서

7 5 4 2 8 7 - 1 0 0   R e v .   A

- 2 -

•  Strip alcove to bare studs.

•  Shower stud pocket should be constructed as shown above.

•  Floor must be clean, smooth, and level (check with level). Sub floor must be 

installed. Do not install shower base on open floor joists.

•  Cut hole in sub floor as shown on page 1 to accommodate drain.

•  Trial fit base in prepared alcove. With pan sitting flat on floor, check with level  

on top of pan. Pan should be level from front-to-back and side-to-side (Fig 1).   
If pan is not level, remove pan and level floor using leveling compound.

•  A floor leveling compound (smooth mortar) or a similar quick-setting compound 

specifically made for leveling floors may be used to fully support and level base.

•  After pan is leveled, if alcove is larger than pan, shim between pan and studs to 

create a tight fit. Drill 3/16" holes in pan flange at each stud. Screw pan flange  
to studs (Fig. 2).

•  Do not use any abrasive cleaners or metal scrapers.

•  If drywall mud or plaster gets on your shower, it may be carefully removed     

with a wooden scraper made from a piece of scrap wood.

•  Adhesive may be removed with mineral spirits.

•  Ideal cleaners are Soft Scrub Gel

®

 or Comet Gel

®

.

FIGURE 1. Check to assure pan is level.

FIGURE 2. If necessary, shim between pan and 
studs for tight fit and screw to each stud.

Tape Measure   

Pencil   

Saber Saw 

 

Screws, 1" Flathead, Stainless 

Safety Glasses   

Drill 

 

24" Level 

 

    

•  Allow pan to reach room temperature before installation.

•  Before you begin, locate appropriate product reference (see page 1).

•  Read installation instructions carefully before starting project.

•  Keep instructions for warranty information