Troy-Bilt 1130 사용자 설명서
6
•
If not already attached, slip the cables that run from
the handle panel to the chute assembly into the
cable guide located on top of the engine. See
Figure 3.
the handle panel to the chute assembly into the
cable guide located on top of the engine. See
Figure 3.
Figure 3
•
If not already attached, unwrap the headlight wire
which is attached to the headlight, beneath the
handle panel. Wind the headlight wire around the
lower right handle until excess slack is removed.
See Figure 4.
which is attached to the headlight, beneath the
handle panel. Wind the headlight wire around the
lower right handle until excess slack is removed.
See Figure 4.
•
Plug the wire from the headlight into the alternator
lead coming from the right side of the engine
underneath the fuel tank.
lead coming from the right side of the engine
underneath the fuel tank.
Figure 4
Clean-Out Tool
•
This tool, along with the electric cord, is fastened
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
SECTION 3: KNOW YOUR SNOW THROWER
Figure 5
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
all instructions and warnings on the
machine and in this manual before
operating.
Drive Control / Auger Control Lock
The drive control is located on the right handle.
Squeeze the drive control to engage the wheel drive.
Release to stop. See Figure 5.
Squeeze the drive control to engage the wheel drive.
Release to stop. See Figure 5.
Cable
Discharge
Chute
Chute
Guide
Cable
Alternator Lead
Lamp Wire
Alternator
Lead
Lead
NOTE:
Wheels are omitted from illustration for clarity.
Drive Control /
Auger Control Lock
Auger Control Lock
Shift Lever
Auger Drive Control
Skid Shoe
Auger
Headlight††
Chute
Assembly
Assembly
Track Steering
Control
Control
Switch
Box
Box
Electric
Starter
Button
Starter
Button
Recoil
Starter
Handle
Starter
Handle
Primer
Choke
Safety
Ignition Key
Ignition Key
Throttle
Control
Control
Chute Tilt
Control
Control
Heated Handles
Switch†
Switch†
Chute Directional
Control
Control
Clean-Out
Tool
Tool
Closed
Open
Fuel Shut-Off Valve
*If Equipped
Heated Grip†
† Model 1028
†† Model 1130 equipped with one (1)