Yamaha AN200 사용자 설명서

Quick Start Guide

Once that you’ve got the AN200 out of the box and checked that all included items were indeed included, it’s
time to set everything up and get playing.

1 Turn the VOLUME control all the way down to the minimum.

2 Connect the OUTPUT jacks (L/MONO and R) to the inputs of your

recorder/mixer/amplifier.

If you’re using a mono system, use only the L/MONO jack. If you’re using headphones, connect them to
the PHONES jack.

3 Plug in the included power adaptor — first, one end into the DC IN termi-

nal, then the other into an AC outlet.

4 Turn on the power with the rear panel power switch. Then, turn on the

power of your recorder/mixer/amplifier.

The AN200 takes a little time to “warm up” after being turned on – roughly 20 seconds. After
the startup routine is finished, your AN200 is ready to play.

5 Press the Start/Stop button on the AN200 to start a Pattern and slowly

turn up the VOLUME control until the level is appropriate.

To stop the Pattern, simply press the Start/Stop button again.

And that’s all there is to it. Now go on to the Tips and start playing!

Headphones

Amplifer

Mixer

Recorder

Adaptor

AN200

DC IN

OUTPUT

PHONES

AC outlet