Yamaha AN200 사용자 설명서
Troubleshooting
115
Appendix
Troubleshooting
Problem
Possible cause/Solution
No power.
Is the adaptor properly plugged into both the AN200 and the AC outlet?
(Page 11)
(Page 11)
No sound.
• Is the panel volume control set to an appropriate level?
• Are other volume-related parameters set to appropriate levels? (Page
• Are other volume-related parameters set to appropriate levels? (Page
• Is the EG Attack Time appropriately short, for short percus-sive
No sound from a particular track.
• Is the track set to a proper Volume? (Page 39)
• Is the Track Mute setting appropriate? In other words, is the track
• Is the Track Mute setting appropriate? In other words, is the track
No sound when playing the keyboard.
Is the [KEYBOARD] button lit? If not press it to enable the keyboard.
(Page 20)
(Page 20)
No sound when playing a connected MIDI keyboard or
other device.
other device.
• Have you connected the MIDI cables properly?
• Are all MIDI channel settings appropriate? (Page 97)
• Are all MIDI channel settings appropriate? (Page 97)
The knobs and other Voice controls have no effect on
the sound.
the sound.
• Is the Synth track selected? (If one of the Rhythm tracks is selected,
some knobs may affect the Rhythm sound instead.)
• Is the Step Edit mode active? In other words, are either of the buttons
[STEP 1-8] or [STEP 9-16] on? (If so, turning some of the knobs may
unexpectedly change some of the recorded steps.) (Page 73)
unexpectedly change some of the recorded steps.) (Page 73)
The Sequence doesn’t play back.
Make sure these are off.
• Have you selected any of these modes — Pattern Job, MIDI Setup, or
Utility?
• When syncing to another MIDI device, have you made sure that the
Recording (either Sequence or Free EG) doesn’t work.
Is the Pattern mode active? Press [PATTERN] to make sure you’re in
Pattern mode.
Pattern mode.
Free EG tracks can’t be recorded.
Turning Free EG tracks on or off has no effect.
Is the Synth track selected?
The length of the notes of the Sequence sounds wrong.
Has the playback Gate Time been set to a value other than “100”? (Page
35)
35)
The pitch of the Sequence sounds wrong.
Has the Transpose Pattern setting been changed? Call up this function
to check the value, and change it if necessary. (Page 66)
to check the value, and change it if necessary. (Page 66)
When playing by the external sequencer, the Step
Sequencer of the AN200 starts.
Sequencer of the AN200 starts.
When playing the AN200 by the AN200 Editor, the Step
Sequencer of the AN200 does not play correctly even if
pressing the [PLAY] button.
Sequencer of the AN200 does not play correctly even if
pressing the [PLAY] button.
• Is the MIDI control set to “On” or “In”? (Page 107)
• Is the MIDI clock set to “Internal”? (Page 97)
• Is the MIDI clock set to “Internal”? (Page 97)
The bulk data cannot be received by the AN200 Editor.
Are the MIDI IN/OUT jacks of the AN200 and the MIDI OUT/IN jacks of
the computer (or MIDI interface) are properly connected? (Page 106)
the computer (or MIDI interface) are properly connected? (Page 106)