Yamaha AN200 사용자 설명서

다운로드
페이지 147
69
Chapter 14  Pattern Recording
57
Setting the Metronome lead-in
When you record your parts in real time, you’ll need a rhythmic guide — a metronome click — to lead you 
into the recording, and keep you in time.  Here, you can set the length of the Metronome lead-in — in other 
words, how long the Metronome clicks before Real-time recording actually starts.
1 Simultaneously hold down [SHIFT] and press [16] (UTILITY SETUP).
You may have to press the button more than once to call up the “mtro” display.
2 Use the DATA knob to change the setting.
For a one-measure lead-in before recording starts, set this to “on1.”  For a 
two-measure lead-in, set this to “on2.”  
You can also turn the Metronome off here, by setting this to “oFF” — in 
which case, recording starts immediately (without a lead-in), as soon as 
you press the Start/Stop button.
When done, press [EXIT] to return to normal operation.
Metronome
Determines the length of the Metronome 
lead-in for Real-time recording.  To turn the 
Metronome (and the lead-in) off, set this to 
“oFF.”  Set this to “on1” for a one-measure 
lead-in, and “on2” for two measures.
Metronome is set in the Utility parameters.  
Hold down [SHIFT] and press button [16], 
repeatedly if necessary, until “mtro” 
appears in the display.  Use the [DATA] knob 
to change the setting.
Settings
oFF
No lead-in metronome click.
on1
A one-measure lead-in before recording.
on2
A two-measure lead-in before recording.