Roland PCR-800 사용자 설명서

 

Here’s how to assign a control change message to a controller.

 

fig.H-Edit.eps

 

Press the [EDIT] button so it’s lit.

 

fig.D-Edit.eps

 

The display will indicate “EDIT.”

 

fig.D-r1.eps

 

Slightly move the controller to which you want to assign a control 
change message.
If the controller is a button, press it.
The display will indicate the number of the controller you selected.

 

Check the indication in the display, then press the [ENTER] button.

 

fig.D-CC.eps

 

Turn the VALUE knob to make “CC” appear.

 

Press the [ENTER] button.

 

fig.D-CCEdit0.eps

 

Turn the VALUE knob or press controller [A1 (0)] to select the basic 
editing “CC0” indication.

 

fig.D-ChannelSelect.eps

 

Press the [ENTER] button.
The display will indicate “CH- -.”

 

Enter the channel.
Use the VALUE knob or controllers [A1 (0)]–[B2 (9)] to specify the desired channel.

 

fig.D-NoteSelect.eps

 

Press the [ENTER] button.
The display will indicate “N- - -.”

 

Enter the control change number.
Use the VALUE knob or controllers [A1]–[A8] and [B1]–[B8] to specify the desired 
control number.

 

Press the [ENTER] button.

 

As appropriate for the type of controller, make button mode settings (p. 64) or 
virtual center click settings (p. 65).

 

Basic editing

[A1 (0)]

1–16

0–127

(00–7FH)

0–127 (00–7FH)

PORT1 

(fixed)

Unlatch, Latch, 

Increase

Advanced editing 1

[A2 (1)]

1–16

0–127

(00–7FH)

You can specify an 

upper and lower limit

PORT1, 
PORT2, 

PORT1+2

Unlatch, Latch, 

Increase

Advanced editing 2

[A3 (2)]

1–16

0–127

(00–7FH)

Simulates a rotary 

encoder

PORT1, 
PORT2, 

PORT1+2

—

PCR-300_500_800_e.book 46 ページ ２００６年１２月１９日　火曜日　午後２時５９分