Roland RM-700 사용자 설명서

 

Connecting External Devices

 

When you have a MIDI sequencer connected, set this parameter to 

Local Off. Most conventional sequencers have the Thru function set 

to On, so as seen in the figure, when information describing what 

has been played on the keyboard (1) arrives at the sound generator 

via two separate routes (2), notes could be sounded twice or 

sometimes get cut off. To prevent this, the setting called “Local Off” 

is used to disconnect the route in (1).

 

The keyboard and the internal sound generator are in a linked state.

 

The keyboard and the internal sound generator are in an unlinked 

state. No sound will be produced by the keyboard when it is played.

 

When a Roland MT series instrument is connected, it is not 

necessary to make the Local Off setting. The MT transmits a 

Local Off message when the power is turned on. If you turn on 

the power in the order of the RM-700 

 

→

 

 MT series, Local Off will 

be set automatically.

When Composer MIDI Out is active, you can send performance data 

recorded with the RM-700 to a connected MIDI device or computer.

A Program Change is a message that means “change to the Tone of 

the specified number.” The device that receives this changes to the 

Tone of the corresponding number.

When you choose a Program Change message (Program Number), 

the Program Number will be transmitted to the MIDI device 

connected to the RM-700. The MIDI device that receives the 

Program Number changes the tone to the corresponding Program 

Number.

Normally, the Tone is selected from the 128 Tones available. Some 

MIDI devices, however, have more than 128 Tones. With such 

devices, the Tone is selected through a combination of Program 

Change messages and Bank Select messages. There are two parts of 

a Bank Select message: the MSB (Controller 0, with a value of 0–127) 

and the LSB (Controller 32, with a value of 0–127).

 

Some MIDI instruments can’t handle Bank Select messages. 

Others can handle Bank Selects, but do not recognize the LSB 

part.

 

Disconnecting the Internal Sound 
Generator and Keyboard (Local Control)

 

The Local Control is set to On. 
The keyboard and internal sound generator are 
connected.

 

The Local Control is set to Off. 
The keyboard and internal sound generator are 
disconnected. Playing the keyboard will not produce 
sound.

MIDI

MIDI

MIDI

MIDI

IN

IN

OUT

OUT

Each note played is 

sounded twice

 

Sending Recorded Performance Data to a 
MIDI Device (Composer MIDI Out)

 

When you turn on the power, this is set to “OFF” (data 
is not sent).

 

Sending Tone Change Messages (Bank Select 
MSB/Bank Select LSB/Program Change)

 

0 (00H)–127 (7FH)

 

1 (00H)–128 (7FH)

RM-700_e.book 198 ページ ２００９年３月１８日　水曜日　午前１１時５分