Roland RM-700 사용자 설명서
201
Appendices
Troubleshooting
If you think there’s a problem, read this first.
Case
Cause/Remedy
The power doesn’t come on
The button doesn’t work
Cancel the Panel Lock function.
Turn the power off, then back on.
Nothing appears on screen
The RM-700 uses a liquid-crystal screen, so text may not be displayed when the ambient temperature is below
freezing.
freezing.
Cancel the Panel Lock function.
Press the [Exit] button or press the [Anime] button to turn off the Anime effect.
The touch screen doesn’t respond correctly
The positioning of the touch screen may become displaced if some time has passed since it was last used. Take a look
at “Calibrating the Touch Screen (Touch Screen)” (p. 188) to correct the positioning.
at “Calibrating the Touch Screen (Touch Screen)” (p. 188) to correct the positioning.
Depressing a pedal has no effect, or the
pedal effect doesn’t stop
Has a different function been assigned to the pedal?
See “Assigning the Function of the Pedals (Left Pedal/Center Pedal/Expression Pedal)” (p. 179).
See “Assigning the Function of the Pedals (Left Pedal/Center Pedal/Expression Pedal)” (p. 179).
The pedal rattles
The volume level of the instrument
connected to Input jacks or Roland Audio
Port is too low
Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.
Use a connection cable that does not contain a resistor.
Unable to read from/write to USB memory
Are you using (optional) Roland memory?
Reliable performance cannot be guaranteed if you use non-Roland memory products.
Remote Control not functioning
No data from the remote control is received when the Remote Sensor is switched off.
Performance begins unexpectedly
If Auto Start is On, the demo will begin if no operation has been performed for five minutes.
No sound is heard
No sound is heard
Is the volume level of the RM-700 (p. 22) or connected device turned all the way down?
Has a plug remained connected to the Phones jack?
When headphones or plugs are connected, the keyboard’s speaker stops playing.
Even if the [VOLUME] knob is raised, there will be no sound if the remote VOLUME [-] [+] buttons or the [MUTE] button
have been pressed to set the volume to “0.”
have been pressed to set the volume to “0.”
The same holds true when Expression has been assigned to the Left Pedal or Center Pedal.
RM-700_e.book 201 ページ 2009年3月18日 水曜日 午前11時5分