Roland SP-555 사용자 설명서
29
Editing a sample
1.
Make sure that [PATTERN SELECT] is extinguished. If it
is lit, press [PATTERN SELECT] to turn it off.
is lit, press [PATTERN SELECT] to turn it off.
2.
Press the pad whose playback region you want to
adjust, making it sound.
adjust, making it sound.
If [MARK] is lit, the start point or end point has already been
adjusted. In this case, cancel the start point/end point setting
(p. 28) before you proceed with the steps below.
adjusted. In this case, cancel the start point/end point setting
(p. 28) before you proceed with the steps below.
3.
While listening to the sound, press [MARK] at the
timing of the desired start point.
timing of the desired start point.
4.
Press [MARK] again at the timing of the desired end
point.
point.
If you specify the BPM (tempo) between steps 3 and 4, the end
point will automatically be set to the location of the beat that is
closest to the timing at which you press [MARK] in step 4 (in
units of beats of the BPM value, beginning at the start point).
To specify the BPM, you can either press [TIME/BPM] so the
button is lit and then turn the CTRL 2 knob, or press [TAP
TEMPO] several times.
point will automatically be set to the location of the beat that is
closest to the timing at which you press [MARK] in step 4 (in
units of beats of the BPM value, beginning at the start point).
To specify the BPM, you can either press [TIME/BPM] so the
button is lit and then turn the CTRL 2 knob, or press [TAP
TEMPO] several times.
1.
Make sure that [PATTERN SELECT] is extinguished. If it
is lit, press [PATTERN SELECT] to turn it off.
is lit, press [PATTERN SELECT] to turn it off.
2.
Hold down [MARK], and press the pad whose
playback region you want to adjust, making it sound.
playback region you want to adjust, making it sound.
3.
When the sound begins to play, release [MARK].
4.
While the sound plays, press [MARK] at the timing of
the desired end point.
the desired end point.
If you press [MARK] to turn off its light while the sound is
playing, the change in the start point and end point will be
cancelled.
playing, the change in the start point and end point will be
cancelled.
1.
Make sure that [PATTERN SELECT] is extinguished. If it
is lit, press [PATTERN SELECT] to turn it off.
is lit, press [PATTERN SELECT] to turn it off.
2.
Press the pad whose playback region you want to
adjust, making it sound.
adjust, making it sound.
If [MARK] is lit, the start point or end point has already been
adjusted. In this case, cancel the start point/end point setting
(p. 28) before you proceed with the steps below.
adjusted. In this case, cancel the start point/end point setting
(p. 28) before you proceed with the steps below.
3.
While listening to the sound, press [MARK] at the
timing of the desired start point.
timing of the desired start point.
4.
Stop the pad playback.
Adjusting both the start point and end
point
point
Start sampling
Unwanted
Unwanted
Press [MARK]
Press [MARK]
This region will sound
Stop sampling
Specified end point
Timing at which
you press [MARK]
you press [MARK]
Beat
Beat
Beat
Beat
Adjusted
Start point
Adjusting only the end point
Adjusting only the start point
SP-555_e.book 29 ページ 2007年6月25日 月曜日 午前9時9分