Roland RE-20 사용자 설명서
6
Installing Batteries
Insert the batteries as shown below, being careful to orient the batteries correctly.
fig.010
• When turning the unit upside-down, get a bunch of newspapers or magazines, and
place them under the four corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no buttons or controls get
damaged.
and controls. Also, you should try to orient the unit so no buttons or controls get
damaged.
• When turning the unit upside-down, handle it with care to avoid dropping it, or
allowing it to fall or tip over.
• Make sure the “+” and “–” ends of the batteries are oriented correctly.
• Batteries are supplied with the unit. The life of these batteries may be limited,
• Batteries are supplied with the unit. The life of these batteries may be limited,
however, since their primary purpose is to enable testing.
• When the batteries run down, the POWER indicator grows dim. If this happens, install
with new batteries.
• When replacing the batteries, use six AA type batteries.
• Avoid using new batteries together with used ones. In addition, avoid mixing different
• Avoid using new batteries together with used ones. In addition, avoid mixing different
types of batteries. Doing so can result in fluid leakage.
• Battery life can vary depending on battery type.
Continuous usage time under battery power is about 32 hours with alkaline batteries
and about 9 hours with carbon batteries. (This may vary according to usage
conditions.)
and about 9 hours with carbon batteries. (This may vary according to usage
conditions.)
RE-20_e.book 6 ページ ２００７年６月８日 金曜日 午後４時３２分