Siemens TC12 사용자 설명서
TC12 Installation, Commissioning & Maintenance Handbook
Comment: The above command is repeated for each OTU on the telephone
U enter its address and the number of reply words
3.3.3.8 Receive Da
GRX={Contro
Comment:- Ins
d
of receive data
ore the CD control line and use a gap
mer instead to detect the start of the receive data from the instation (1).
elephone line communications using modems.
he gap timer is used for RS232 serial link communications.
3.3.3
Add onal
ropa
PD=
elay: to 9
al n
ber
nds of
ropagation delay to its calculations.
being made
esent
at the Instation
3.3.3.10 Enable/Disable OTU control and reply facility (GOE)
omm nt:
ause
function to be enabled (1)
nd checked.
3.3.3.11 SCOOT loop input allocation (GSA)
he number of the scoot loop and the input (on Buffered
ote.
ing to
nputs.
3.3.3.12
t no.: 0 to 30} (255)
Comment: Unidirectional loop allocation on a free standing OTU. Repeat this
d for up to four unidirectional loops. For each unidirectional
d enter the number of the loop (0 to 3) and the input (on
uffere
ectio 3.2.3
the
line. For each OT
it uses.
it uses.
ta Control Mode (GRX)
l Mode: 0 or 1 (0)}
tructs the OTU to use the CD control line to detect the start and en
from the instation (0) or ign
from the instation (0) or ign
ti
The CD control line is used for t
T
The CD control line is used for t
T
.9
iti
P
gation Delay (GPD)
G
{D
0
0 (0)}
Comment:- Instructs the OTU to include an addition
um
of milliseco
p
Propagation delay is considered to be the time from a signal transition
on the OTU UART Tx line to the same transition being pr
Propagation delay is considered to be the time from a signal transition
on the OTU UART Tx line to the same transition being pr
ed
UART Rx line (or vice versa).
GOE=1 (0)
C
e
C
s the OTU UTC control and reply
or disabled (0). The facility should not be enabled until all the
required configuration items have been set up a
required configuration items have been set up a
Commands to set up digital inputs and reply bytes
GSA, GUD, GRL, GIS
GSA{Scoot loop no.: 0 to 11}={Digital input no.: 0 to 31} (255)
Comment: Repeat this command for up to 12 scoot loops. For each scoot loop
used enter t
Input Connector PL2 see section 3.2.3.5) to which its detector
output signal connects.
Input Connector PL2 see section 3.2.3.5) to which its detector
output signal connects.
N
The 32 inputs are numbered 1 to 32 in section 3.2.3.5, correspond
the associated pin on the 40 way input connector, however the handset
command numbers the inputs from 0 to 31, for the 32 i
the associated pin on the 40 way input connector, however the handset
command numbers the inputs from 0 to 31, for the 32 i
Unidirectional loop allocation (GUD)
UD{U/D loop no.: 0 to 3}={Digital inpu
G
comman
loop use
B
loop use
B
d Input Connector PL2 see s
n
.5) to which
666/HE/43100/000
Page 90
Issue 9