Crate Amplifiers GFX-120/212 사용자 설명서
• Slapback delay
• Long delay w/regeneration
• Light Flange
• Heavy Flange
• Slow Chorus
• Fast Chorus
• Chorus w/small room reverb
• Chorus w/large room reverb
• Small room reverb
• Large room reverb
• Long delay w/regeneration
• Light Flange
• Heavy Flange
• Slow Chorus
• Fast Chorus
• Chorus w/small room reverb
• Chorus w/large room reverb
• Small room reverb
• Large room reverb
16: INSERT: Connect an external effects device
via this jack. Use a stereo 1/4” male Y-cord: ring =
send, tip = return, sleeve = ground. See the illus-
tration on the panel to the right for more informa-
tion.
via this jack. Use a stereo 1/4” male Y-cord: ring =
send, tip = return, sleeve = ground. See the illus-
tration on the panel to the right for more informa-
tion.
17: EXT. SPEAKER: Connect to an extension
speaker cabinet with this jack. The jack is wired in
series with the internal speaker(s).
speaker cabinet with this jack. The jack is wired in
series with the internal speaker(s).
18: POWER ON LED: Lights when the amplifier is
turned on.
turned on.
19: POWER SWITCH: Turns the amplifier ON in
the up position, off in the down position.
the up position, off in the down position.
20. POWER CORD (rear panel, not shown): Your
GFX-120/212 is equipped with a heavy-duty
grounded three-wire power cord. Be sure this cord
is properly plugged into a safely wired grounded
120 volt, 60Hz AC power outlet before use. (If your
GFX-120/212 was purchased outside the United
States, refer to the rear panel for power ratings.)
For your safety, never attempt to defeat the ground
connection on this cord.
GFX-120/212 is equipped with a heavy-duty
grounded three-wire power cord. Be sure this cord
is properly plugged into a safely wired grounded
120 volt, 60Hz AC power outlet before use. (If your
GFX-120/212 was purchased outside the United
States, refer to the rear panel for power ratings.)
For your safety, never attempt to defeat the ground
connection on this cord.
21: FUSE (rear panel, not shown): Protects the
amplifier against damages caused from a faulty AC
power source or other problems. If the fuse blows,
replace it ONLY with the same size and type fuse.
If the fuse blows repeatedly check the AC source;
if it’s okay, contact your Crate dealer for service
information.
amplifier against damages caused from a faulty AC
power source or other problems. If the fuse blows,
replace it ONLY with the same size and type fuse.
If the fuse blows repeatedly check the AC source;
if it’s okay, contact your Crate dealer for service
information.
22: CHANNEL SELECT / GAIN FOOTSWITCH
JACK (rear panel, not shown): Connect the
stereo 1/4” plug of the supplied three-button
footswitch here for remote control of the Channel
Select and Gain Select settings.
JACK (rear panel, not shown): Connect the
stereo 1/4” plug of the supplied three-button
footswitch here for remote control of the Channel
Select and Gain Select settings.
23: DSP FOOTSWITCH JACK (rear panel, not
shown): Connect the mono 1/4” plug of the sup-
plied three-button footswitch here for remote con-
trol of the DSP on and off.
shown): Connect the mono 1/4” plug of the sup-
plied three-button footswitch here for remote con-
trol of the DSP on and off.
Connecting to the Insert jack:
The Insert jack (#16) lets you patch external effects
into the amplifier just prior to its power amp stage.
Use Crate’s STP201, STP202 or STP203 stereo-
to-mono Y-cord or an adapter such as Crate’s
YPP117 and 2 1/4” mono signal cables to connect
to the effect as shown below.
into the amplifier just prior to its power amp stage.
Use Crate’s STP201, STP202 or STP203 stereo-
to-mono Y-cord or an adapter such as Crate’s
YPP117 and 2 1/4” mono signal cables to connect
to the effect as shown below.
GFX-120/212 Amplifier
TIP
RING
SLEEVE
RING
SLEEVE
RETURN
SEND
GROUND
Stereo-to-mono Y-cord:
to Insert
jack
to Insert
jack
jack
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
(1/4"-TO-1/4"
MONO SHIELDED
CABLES)
to
effect
"OUT"
jack
to
effect
"IN"
jack
External Effect
TIP
RING
SLEEVE
Y-adapter and 2 cables:
External Effect
RING
RING
TIP
TIP
to
effect
"OUT"
jack
to
effect
"IN"
jack
12
13
14
15
16
17
19
18