QSC Audio 10 SERIES 사용자 설명서
2
WLX0001 rev. B
4.
WL3082 and WL212-sw only: Remove the screws in the rigging bars (three screws on the WL3082; two screws on the
WL212-sw). See Figure 3. These screws may have either TORX or Phillips heads. Apply a dab of Loctite QuickStix 248 to the
thread at the end of each screw. Reinstall and lightly secure the screws using a power drill-screwdriver at its lowest torque
setting.
WL212-sw). See Figure 3. These screws may have either TORX or Phillips heads. Apply a dab of Loctite QuickStix 248 to the
thread at the end of each screw. Reinstall and lightly secure the screws using a power drill-screwdriver at its lowest torque
setting.
5.
All models: Use the torque wrench, set to 60 in-lb or 7 N-m, to tighten the screws to the proper torque.
6.
WL2102-w and WL218-sw only: Reinstall the knuckle into the channel, while making sure its orientation is correct (Figure 4).
Fasten the cap head screw to the knuckle.
Fasten the cap head screw to the knuckle.
7.
All models: Repeat steps 1 through 6 with the rigging channel or channels on the other end of the loudspeaker enclosure.
8.
WL2102-w and WL218-sw only: Remove all twelve screws on the input plate/rear rigging point and apply Loctite QuickStix
248.
248.
➜ Continued
Continued on next page
➜
Figure 2. Removing the rigging channel screws. Apply threadlock,
then reinstall and torque them. The WL2102-w has two screws on
each side, while the WL218-sw and WL3082 have four, and the
WL212-sw has six. On the WideLine 8 cabinets, the anchors of the
rigging pin lanyards must be attached as shown when the screws
are reinstalled.
then reinstall and torque them. The WL2102-w has two screws on
each side, while the WL218-sw and WL3082 have four, and the
WL212-sw has six. On the WideLine 8 cabinets, the anchors of the
rigging pin lanyards must be attached as shown when the screws
are reinstalled.
WL2102-w
WL218-sw
WL3082
WL212-sw