Roland TD-8KV 사용자 설명서

 

• The tips of the anchor bolts are sharp. Handle with care.
• When using on flooring, the anchor bolts may damage 

the floor. Do not attach the anchor bolts.

• When the FD-6 is not going to be used for a long period 

of time, move and fix the arm, allowing longer travel for 
the pedal.

• To avoid damage, do not leave the FD-6 for extended 

periods of time with the pedal plate depressed.

 

The TD-8 owner's manual assumes use of the FD-7 Hi-Hat 
Control Pedal. For each instance in which you find “FD-7” 
mentioned in the TD-8 owner's manual, please substitute the 
name “FD-6.” 

 

Dimensions: 160 (W) x 395 (D) x 120 (H) mm

6-5/16 (W) x 15-9/16 (D) x 4-3/4 (H) inches

Weight: 1.4 kg

3 lbs 2 oz (including anchor bolts)

 

Attach the stand holder (included with the drum stand) to the 
TD-8.

 

fig.TD01.e

 

• To attach the stand holder, remove the four 12 mm 

screws (M5 x 12) from the bottom of the TD-8 and use 
them. Use of other screws may result in damage to the 
unit.

• When turning the unit upside-down, get a bunch of 

newspapers or magazines, and place them under the four 
corners or at both ends to prevent damage to the buttons 
and controls. Also, you should try to orient the unit so no 
buttons or controls get damaged.

• When turning the unit upside-down, handle with care to 

avoid dropping it, or allowing it to fall or tip over.

Loosen the bolt with the included tuning 

key. After adjusting, tighten the bolt.

Shift the Arm

deep

shallow

Control Out Jack

Pedal Plate

Anchor Bolt

Spring for 
the Anchor Bolt

Wide

Narrow