Land Pride RTR1258 사용자 설명서

1.

Park tractor and tiller on a level surface. Raise tiller to
align gearbox input shaft level with tractor PTO shaft.
Securely block tiller at this height to keep unit from
lowering while attaching the driveline.

2.

Place gear selector in park, shut tractor engine off,
set park brake and remove switch key.

Refer to Figure 1-3 on page 11 for RTA12 or
Figure 1-5 on page 12 for RTR12

3.

Remove gearbox shaft protector (#24) from end of
gearbox shaft and attach slip clutch end of
driveline (#25) to gearbox input shaft.

IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to “Lubrication
Points” on page 25 for detailed instructions.

IMPORTANT: Drivelines with friction clutches must
go through a “run-in” operation prior to initial use
and after long periods of inactivity.See “Driveline
Protection” on page 22 for detailed instructions.

IMPORTANT: If tiller is to be used on more than one
tractor, an additional driveline may be required,
especially if a quick hitch is used.

IMPORTANT: The tractor’s PTO shaft and tiller
gearbox shaft must be aligned and level with each
other during installation of driveline. This alignment
is the shortest distance between the two shafts.

4.

Attach other end of driveline to tractor PTO shaft.

5.

Move driveline yokes back and forth to ensure both
ends are secured to the shafts. Reattach any yoke
that is loose.

6.

Attach safety chain on the outer driveline shield to
the tractor frame to restrict outer shield from rotating.
Re-latch safety chain to outer driveline shield.

7.

Attach safety chain on the inner driveline shield to
the tiller frame to restrict inner shield from rotating.
Re-latch safety chain to inner driveline shield.

1.

Make sure driveline is installed properly before
checking driveline collapsed length (Refer to
“Driveline Installation” instructions on page 13).

2.

With driveline level, measure 1" (“B” dimension)
back from universal joint shield to end of outer
driveline shield as shown in Figure 1-8.

a. If measurement is less than 1", shorten driveline.

a. If measurement is 1” or more, skip to “Check

NOTE: If driveline is too long to fit between tractor
and tiller, skip to “Shorten Driveline” on page 15.

IMPORTANT: Two safety chains are supplied with
the driveline. To keep driveline shields from rotating,
these chains must be attached to the outer and inner
driveline shields and to the tiller and tractor.

IMPORTANT: A driveline that is too long can bottom
out causing structural damage to tractor and tiller.
Always check driveline collapsed length during initial
setup, when connecting to a different tractor, and
when alternating between using a quick hitch and a
standard 3-point hitch. More than one driveline may
be required to fit all applications.

30563