Land Pride RTR1258 사용자 설명서
18
RTR12 & RTA12 Series (Serial No. 884764-) Rotary Tillers 311-785M
8/12/14
Section 2: Operating
Transporting
Refer to Figure 2-1:
!
CAUTION
1.
When raising tiller to transport position, be sure the
driveline does not contact tractor or tiller. Adjust
tractor’s 3-Point hitch lift height so that the tiller tines
are not lifted more than 14 inches off the ground to
prevent driveline damage.
driveline does not contact tractor or tiller. Adjust
tractor’s 3-Point hitch lift height so that the tiller tines
are not lifted more than 14 inches off the ground to
prevent driveline damage.
Refer to Figure 2-1:
2.
Remove parking stand (#4) from support tube, turn
stand upsidedown and replace through top of
support tube as shown. Secure stand with wire
retaining pin (#5).
stand upsidedown and replace through top of
support tube as shown. Secure stand with wire
retaining pin (#5).
Parking Stand in Transport Position
Figure 2-1
3.
Be sure to reduce tractor ground speed when
turning, and leave enough clearance so tiller does
not contact obstacles such as buildings, trees or
fences.
turning, and leave enough clearance so tiller does
not contact obstacles such as buildings, trees or
fences.
4.
Select a safe ground travel speed when transporting
from one area to another. When traveling on
roadways, transport in such a way that faster moving
vehicles may pass you safely.
from one area to another. When traveling on
roadways, transport in such a way that faster moving
vehicles may pass you safely.
5.
When traveling over rough or hilly terrain, shift tractor
to a lower gear.
to a lower gear.
30350A
Parking
The following steps should be taken when preparing to store
the tiller or unhitch it from the tractor.
the tiller or unhitch it from the tractor.
Refer to Figure 2-2:
1.
Adjust right-hand skid shoes (#1) down before
unhitching tiller from the tractor:
unhitching tiller from the tractor:
a. Loosening pivot bolt (#2A) at the shoe’s front.
b. Remove adjusting bolt (#2B) at the shoe’s rear.
c. Pivot skid shoe down and replace pivot bolt (#2B)
and lock washer (#3) in the second hole down
from the top as shown.
from the top as shown.
d. Tighten bolts (#2A & #2B) to the correct torque.
2.
Repeat step 1 to adjust the left-hand skid shoe down.
3.
Remove parking stand (#5) from support tube, turn
stand upright and replace it through bottom of
support tube.
stand upright and replace it through bottom of
support tube.
4.
Set parking stand (#5) to desired height for re-hook-
up and install wire retaining pin (#4) to lock in place.
up and install wire retaining pin (#4) to lock in place.
5.
Park tiller on a level, solid area. Shut tractor engine
off and engage parking brake.
off and engage parking brake.
6.
Unhitch tiller from tractor.
!
WARNING
7.
After unhooking tiller, check tiller for stability by
physically applying pressure at the hitch plates to
see if it will tip forward or backwards. If the tiller
moves in either direction, then block under the tiller
as needed to prevent that movement.
physically applying pressure at the hitch plates to
see if it will tip forward or backwards. If the tiller
moves in either direction, then block under the tiller
as needed to prevent that movement.
8.
See “Storage” on page 24 for additional information
on long term storage of your tiller.
on long term storage of your tiller.
Parking Stand & Skid Shoe in Parking Position
Figure 2-2
30351A