Acu-Rite 1604 사용자 설명서

Mount the sensor at a minimum height of 5 feet (1.5 meters) 

off the ground, in an open area. Higher is better for wind measurements - the 

National Weather Service recommends 33 feet high!

 The included mounting bracket is designed to screw directly 

onto wooden posts or surfaces that are 2”x4” or larger. The sensor can also be 

mounted directly to 3/4” steel or  

PVC pipe (available at hardware 

stores and home centers).

Use a 

bubble level (not included) to ensure 

level installation for accurate wind 

measurement.

1.  Insert the mounting base into the 

hole on the bottom of the sensor.

2.  Use one of the screws included 

in the hardware bag to fasten 

the lower sensor housing to the 

mounting base.

3.  Fasten mounting base to a post or railing 

using 2 screws.

1. Insert pipe or similar item all the way into 

the hole on the bottom of the sensor. Note: 

Mounting base is not used.
2. Use one of the screws included in the 

hardware bag to fasten the lower sensor housing securely to the pipe.
The 3-in-1 sensor is now ready to use.

The 3-in-1 sensor will now synchronize with the display unit. It may take a few 

minutes for synchronization to complete. If both or one of the units appear to be 

functioning improperly, please refer to the troubleshooting section.

Do not install during 

electrical storms.  

Do not place pipe  

or sensor near 

electrical lines or 

electrical equipment.