Troy-Bilt 643C Tuffy/Bronco 사용자 설명서

다운로드
페이지 32
7
through the wheel shaft (L) only (not 
through the wheel hub).  The wheel should 
now spin freely (freewheel) on the wheel 
shaft. Repeat with the other wheel.
4. Use the handlebar to roll the tiller to a 
flat area.
IMPORTANT: 
Before starting the engine, 
the wheels must be placed in the WHEEL 
DRIVE position (pins through wheel hubs 
and wheel shaft). This procedure is 
described in Wheel Drive Pins on page 10.
STEP 4: INSTALL FORWARD 
CLUTCH CABLE
1. Carefully unwrap the forward clutch ca-
ble (cable without an attached knob) from 
its shipping position and slide the thin ca-
ble wire (M, Fig. 2-4) into the slot in the ca-
ble bracket. Push the cable connector (N, 
Fig. 2-4) up through the hole in the bracket 
until the groove in the connector snaps 
into place. 
2. Thread the #10-24 hex nut (Z, Fig. 2-5) 
halfway onto the screw (V) which runs 
through the spring (W, Fig. 2-5). 
3. Thread the screw (V) into the cable ad-
juster (X).
C
H
B
D
G
F
E
I
F
A
Fig. 2-3: Wheel in FREEWHEEL position 
(wheel drive pin through wheel shaft only).
J
K
L
Fig. 2-4: Installing forward clutch cable bracket and cable.
Fig. 2.2: Attach handlebar.
M
N
M
The support brackets must 
be assembled to the outside 
of the handlebar assembly.