Oregon Scientific BAR626 사용자 설명서

6

EN

The clock automatically synchronizes the current time
and date when it is brought within range of the radio
signal DCF77 generated from Frankfurt, Germany for
Central Europe (model BAR626) or MSF60 generated
from Rugby, England (model BAR626U).

NOTE The signals are collected by the main unit when
it is within 1500 km (932 miles) of a signal.

Initial reception takes 2-10 minutes, and is initiated when
you first setup the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking. The
icon is shown in the Clock Area.

Perform this step if you cannot receive clock signals.
Press and hold       for 2 seconds. Then, manually set
the clock following the "Set Clock" instructions (below).

To force a manual search for clock signals, press and
hold       for 2 seconds. If no signal is found, check the
batteries.

The signal icon indicates that the clock feature is

ON. No icon means that it is OFF.

You only need to do this if you have disabled the clock
feature (for example, if you are too far from or cannot
receive a signal).

1. Press and hold MODE for 2 seconds. The Clock Area

will blink.

2. Select the hour, minute, year, month, day, and day

of the week language. Press        or        to change
the setting.

3. Press MODE to confirm.

The language options are (E) English, (F) French, (D)
German, (I) Italian, and (S) Spanish.

Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.

This product is equipped with a 2-minute crescendo
alarm.

Press           . The alarm time and alarm status will show
in the Clock Area.

1. Press           to switch to alarm display.
2. Press and hold           again for 2 seconds. The alarm

settings will blink.

3. Select the hour and minute. Press       or       to

change settings. Press           to confirm.

Press         to activate or deactivate the alarm.        shows
in the Clock / Alarm Area when the alarm is activated.

When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:

¥ Press SNOOZE to silence it for 8 minutes.

OR

¥ Press any key except SNOOZE to mute the alarm

and activate it again after 24 hours.

If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.