Poulan HDF550N 사용자 설명서
5
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
(See Fig. 2)
CAUTION: Be careful of exposed
sta ples when handling or disposing
of cartoning material.
sta ples when handling or disposing
of cartoning material.
IMPORTANT:
WHEN UNPACKING AND AS
SEM BLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
CABLE(S).
• Cut cable ties securing handles.
• Slowly lift handle as sem bly up, route cable(s) as shown
• Slowly lift handle as sem bly up, route cable(s) as shown
and align han dle holes with handle panel hole and
slot.
slot.
• Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt is assembled in lower
hole of handle. Repeat for opposite side. Tight en all
hardware se cure ly.
hole of handle. Repeat for opposite side. Tight en all
hardware se cure ly.
• Cut cable ties securing tiller to skid and remove tiller
from skid.
• Remove screws securing depth stake to skid and dis-
card the screws.
depth_stak
e_4
DEPTH
STAKE
STAKE
SUPPORT
BOLT
BOLT
HEX BOLTS,
LOCK WASH ERS,
AND HEX NUTS
LOCK WASH ERS,
AND HEX NUTS
DEPTH STAKE
SUPPORT
SUPPORT
NUT “A”
ENGINE BRACK ET
HALVES
HALVES
FIG. 3
STAKE
SPRING
SPRING
TILLER
HANDLES
HANDLES
02051
CABLE(S)
FIG. 2
handles_
38
HANDLE
PANEL
BOLTS
PANEL
BOLTS
FLAT
WASHER
WASHER
HEX BOLT
5/16-18X3/4"
5/16-18X3/4"
TILLER
HANDLE
HANDLE
HAN DLE
PANEL
PANEL
NUT
LOCK
WASH ER
WASH ER
HEX BOLT
5/16-18X1"
5/16-18X1"
ASSEMBLY
HANDLE HEIGHT
• Handle height may be adjusted to better suit operator.
(See “HANDLE HEIGHT” in the Service and Ad just -
ments section of this manual).
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle your
tilling con di tions (See “TINE ARRANGEMENT” in the
Service and Adjustments section of this manual).
Service and Adjustments section of this manual).
TINE OPERATION
• Check tine operation before fi rst use. (See “TINE OP-
ERATION CHECK” in the Service and Adjustments
section of this manual).
section of this manual).
INSTALL DEPTH STAKE AS
SEM BLY
(See Fig. 3)
• Loosen nut “A”.
• Insert stake support between engine brack et halves
• Insert stake support between engine brack et halves
with stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tight en se curely. Tighten nut “A”.
• Depth stake must move freely. If it does not, loosen
support bolt.