Poulan HDF550 사용자 설명서

IMPORTANT: 

WHEN UNPACKING AND AS 

SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK 
CABLE(S).

•      Cut cable ties securing handles.
•      Slowly lift  handle as sem bly up, route cable(s) as shown  

and align han dle holes with handle panel hole and 
slot.

•     Loosely assemble hardware as shown.  Be sure the

shorter (3/4" long) hex bolt is assembled in lower 
hole of handle.  Repeat for opposite side.   Tight en all 
hardware se cure ly. 

•     Cut cable ties securing tiller to skid and remove tiller 

from skid.

•      Remove screws securing depth stake to skid and dis-

card the screws.

depth_stak

e_4

handles_

38

•      Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just -
ments section of this manual).

•     Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 
Service and Adjustments section of this manual).

•      Check tine operation before fi rst use.  (See “TINE OP-

ERATION CHECK” in the Service and Adjustments 
section of this manual). 

•      Loosen nut “A”.
•      Insert  stake  support  between  engine  brack et halves 

with stake spring down. 

•      Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tight en se curely. Tighten nut “A”.

•     Depth stake must move freely. If it does not, loosen 

support bolt.