Poulan 433091 사용자 설명서

de

pth_

st

ak

e_

4

Hex Bolts, Lock Wash ers, and hex Nuts

Support Bolt

Depth Stake Support

Engine Bracket Halves

Nut “A”

Depth 

Stake

Stake Spring

Tine 

Con trol 

Cable

Handle 

Mount

Handle 

Column

Tine Con trol 

Flange 

Lock nut

Carriage 

Bolt

•  Loosen nut “A”.
•  Insert stake support between engine bracket halves 

with stake spring down. 

•  Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tighten se curely. Tighten nut “A”.

•  Depth stake must move freely. If it does not, loosen 

support bolt.

IMPORTANT: 

WHEN UNPACKING AND AS SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK 

CABLE(S).

•  Cut cable ties securing handle column.
• 

Route cable(s) as shown and slide handle column onto 

handle mount.

•  Remove all packing from carton.
• 

Secure handle column using two (2) carriage bolts and 

two (2) flange locknuts. Tighten se cure ly.

•  Cut away carton.
•  Route tine control cable(s) through plas tic cable clip 

on handle mount.

NOTE: Cables must not touch the muffler.
• 

Cut cable ties securing tiller to skid.  Re move tiller from 

skid by pulling backwards. 

•  Remove screws securing depth stake to skid and 

discard the screws.  

•  Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just-

 ments section of this manual).

•  Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 

Ser vice and Adjustments section of this manual).

•  Check tine operation before first use.  (See “TINE 

OPERATION CHECK” in the Service and Adjustments 

section of this manual).