Poulan DRT900 사용자 설명서

• 

Grasp handle assembly.  Hold in “up” position.  Be sure 

handle lock remains in gearcase notch.  Slide handle 

assembly into position.

IMPORTANT: WHEN  UN PACK ING AND AS SEM BLING TILLER, 

BE CAREFUL NOT TO STRETCH OR KINK CABLES.

• 

While holding handle assembly, cut cable ties se cur ing 

handle assembly to top frame and depth stake.  Let 

handle assembly rest on tiller.

•  Remove top frame of carton.
•  Slowly ease handle assembly up and place on top of 

carton.

•  Cut down right hand front and right hand rear cor ners 

of carton, lay side carton wall down.

•  Remove packing material from handle assembly.

car

ton

_3

•  Insert one handle lock (with teeth facing outward) in 

gearcase notch.  (Apply grease on smooth side of 

handle lock to aid in keeping lock in place until handle 

assembly is lowered into position.)

hand

les_

34

• 

Rotate handle assembly down. Insert rear carriage bolt 

first, with bolt head on L.H. side of tiller and loosely 

assemble locknut (See Fig. 5).

•  Insert pivot bolt in front part of plate and tighten.
•  Cut down remaining corners of carton and lay panels 

flat.

•  Lower the handle assembly. Tighten nut on carriage 

bolt so handle moves with some resistance. This will 

allow for easier adjustment.

•  Place flat washer on threaded end of handle lock le-

ver.

•  Insert handle lock lever through handle base and 

gearcase. Screw in handle lock lever just enough to 

hold lever in place.

•  Insert second handle lock (with teeth in ward) in the 

slot of the handle base (just inside of washer).

•  With handle assembly in lowest position, securely 

tight en handle lock lever by rotating clockwise.  Leav-

 ing handle assembly in lowest position will make it  

easier to remove tiller from carton.