Poulan 190388 사용자 설명서

•         Remove belt guard as described in “TO REMOVE BELT 

GUARD”.

•      Remove old belt by slipping off engine pulley fi rst then 

remove from transmission pulley.

•     Place new  belt in groove of transmission pulley and 

into engine pulley.  BELT MUST BE IN GROOVE ON 
TOP OF IDLER PULLEY.  NOTE POSITION OF BELT 
TO GUIDES.

•      Check belt adjustment as described below.
•      Replace belt guard.
•     Reposition wheel and replace clevis pin and hairpin 

clip.

For proper belt tension, the extension spring should have 
about 5/8 inch (16 mm) stretch when drive control bar is 
in “EN GAGED” position.  This tension can be attained as 
follows:
•     Loosen cable clip screw securing the drive control 

cable.

•     Slide cable forward for less tension and rearward for 

more tension until about 5/8 inch (16 mm) stretch is 
obtained while the drive control bar is engaged.

•      Tighten cable clip screw securely.

NOTE:  For ease of removal, remove hairpin clip and clevis  
pin from left wheel.  Pull wheel out from tiller about 1 inch 
(2.5 cm).
•      Remove two (2) screws from side of belt guard.
•      Remove hex nut and washer from bottom of belt guard 

(located behind wheel).

•      Pull belt guard out and away from unit.
•      Replace belt guard by reversing above procedure.