Bushnell 950007 사용자 매뉴얼

다운로드
페이지 27

1. Connect AC adapter or Install Batteries
The 
WeatherFX
  units  can  all  run  on  either  batteries  or  an  AC 
adapter (included with some models). See the “Parts Guide” page for 
a list of battery and AC adapter requirements. NoteWhen running 
on  battery  power,  the  backlight  function  of  the  5-Day  and  7-Day 
units is not available.
To use battery power, open and set aside the battery compartment 
cover  (slide  it  up  in  the  direction  of  the  arrow  on  the  cover)  and 
insert batteries (not included, use alkaline or lithium). Make sure the 
batteries are installed as indicated inside the battery compartment; 
note that all positive (+) terminals face the same direction (towards 
the right when looking at the back of the unit), with the negative 
(-)  terminals  in  contact  with  the  springs. 
Replace  the  battery 
compartment cover, putting it back in place 
with the arrow at the 
bottom of the door, then slide it down until it clicks into place.
To use AC power, simply insert the plug at the end of the AC adapter 
wire into the power jack, located on the back of the unit, on the left 
side  of  the  indented  area  below  the  fold-out  easel. Then  plug  the 
adapter into a wall outlet. 
Basic Setup (all models)
Weather FX-All Models 1LIM-rev2.3   3
8/3/07   8:53:06 AM