Jacuzzi J - 460 사용자 설명서

다운로드
페이지 104
Page 1
J-400
1.0  Important spa Owner Information
Your Jacuzzi® spa is constructed to the highest standards and is capable 
of providing many years of trouble-free use. However, because heat reten-
tive materials are utilized to insulate the spa for efficient operation, an 
uncovered spa surface and wall fittings directly exposed to sunlight and 
high temperatures for an extended period is subject to permanent damage 
or discoloration. Damage caused by exposing the spa to this abuse is not 
covered under warranty. We recommend that you always keep the spa full 
of water when it is exposed to direct sunlight and that you keep the Jacuzzi 
insulating cover in place at all times when the spa is not in use. Read and 
carefully follow the requirements for your spa’s support base found in the 
Section 4.0 titled, “Choosing a Location” (page 8).
Jacuzzi® spas constantly strives to offer the finest spas available, 
therefore, modifications and enhancements may be made which affect 
the specifications, illustrations and/or instructions contained herein.
2.0  FCC notice
This device complies with part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for 
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
1.  Rearrange or relocate the receiving antenna;
2.  Increase the separation between the equipment and receiver;
3.  Connect the equipment into an outlet on a circuit different from the 
circuit connected;
4.  Consult the dealer or an experienced radio/TV technician for help. 
(Changes or modifications not expressly approved by the party 
responsible for FCC compliance could void the user’s authority to 
operate this equipment.)
2.1  Industry Canada (IC) Information
The installer of this radio equipment must ensure that the antenna is 
located or pointed such that it does not emit RF field in excess of Health 
Canada limits for the general population; consult Safety Code 6, 
obtainable from Health Canada’s website: www.hc-sc.gc.ca/rpb.