Grizzly G0755 사용자 설명서

Model G0755 (Mfg. Since 1/13)

-19-

SEcTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.

Due to the generic nature of this overview, it is

not intended to be an instructional guide. To learn
more  about  specific  operations,  read  this  entire
manual  and  seek  additional  training  from  expe-
rienced  machine  operators,  and  do  additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.

To reduce your risk of

serious injury, read this

entire manual bEFORE

using machine.

If you are not experienced with this type

of machine, WE STRONGLY REcOMMEND

that you seek additional training outside of

this manual. Read books/magazines or get

formal training before beginning any proj-

ects. Regardless of the content in this sec-

tion, Grizzly Industrial will not be held liable

for accidents caused by lack of training.

To reduce risk of eye or face injury from

flying chips, always wear approved safety

glasses and a face shield when operating

this machine.

To complete a typical operation, the operator
does the following:

1. Examines workpiece to make sure it is suit-

able for cutting.

2. puts on protective gear.

3. securely clamps workpiece to table.

4. With machine disconnected from power,

installs correct cutting tool.

5. Adjusts headstock height above table.

6. Without the machine running, checks range

of table or spindle movement to make sure
setup is safe and correct for operation.

7. selects correct spindle speed.

8. Connects machine to power and turns it ON.

9. uses downfeed controls or table controls to

perform cutting operation.

10. turns machine OFF and waits for spindle to

completely stop before removing workpiece.