Festool PD561432 사용자 설명서

14 

TS 55 REQ

The limit stop serves two purposes: it controls the saw’s 

starting position and prevents a kickback during a plunge 

cut. The leading edge of the limit stop prevents the saw 

from lifting up at the beginning of a plunge cut. This is what 

prevents kickback during a plunging operation. Refer to 

1.  Slide the limit stop onto the T-slot of the guide rail 

behind the saw, and with the embossed arrow pointing 

toward the saw.

2.  Position the stop behind the starting position of the saw.

 

►

When the blade is at full-depth, the limit stop is 3¾ 

inches behind the start of the cut.

 

►

When the blade is less than full depth, the distance 

between the blade (cut) and the limit stop will be 

greater.

 

►

For best results, you should always verify the blade’s 

cutting position before staring the cut.

3.  Tighten the thumbscrew on the limit stop.

Guide Rail 

T-Slot

Back of 

Saw

Limit 

Stop

Clamping 

Thumbscrew

The TS55 can be used with or without a dust extraction 

system. The chip diverter swivels to direct the sawdust away 

from the work area when a dust extraction system is not 

used.
For best results, however, a dust extraction system (such 

as the Festool CT 22 shown below) should be used. Festool 

dust extractors have the added features of variable speed, 

and sensing when the saw is turned on. The vacuum will 

automatically start when the saw is turned on, and will 

remain running for a couple of seconds after the saw turns 

off to clear the remaining dust.

Saw’s 

Power Cord

Power Switch 

Set to Auto

1.  Insert the extractor hose on to the chip diverter.

 

►

The 27mm Festool hose fits inside the diverter, and the 

36mm Festool hose fits over the diverter.

 

►

The diverter ID is 35mm (1⅜”), and the OD is 39mm 

(1

9

⁄

16

”).

2.  Plug the TS 55 power cord into the auxiliary outlet on the 

extractor (if so equipped).

3.  Set the power switch on the extractor to “Auto.” (The 

auxiliary power outlet is active only when the switch is 

set to Auto.)

27mm 

Vac Hose