Festool DF 500 사용자 설명서

Congratulations on your purchase of a new Festool Domino 

Tenon Joiner. The Domino joiner is the finest portable loose 

tenon joiner in the world. Before using your new Domino 

joiner, make sure you fully read and understand all of the 

precautions and safety information presented in this 

manual.  

  WARNING: Always disconnect the tool from the 

power supply before making any inspections or 

adjustments, or before installing or removing any 

accessory! 

1. 

With the joiner unplugged, inspect the mortising bit. 

Make sure it is not bent, chipped, or otherwise 

damaged, and make sure the bit is fully tightened on the 

  WARNING: Check regularly whether the mortising 

bit is in good condition. Mortising bits that are bent or 

damaged should no longer be used. 

2. 

Peel off the protective film from the bottom of the joiner 

baseplate.  

3. 

Set up the joiner for the appropriate type of operation as 

described throughout the remainder of this section. 

4. 

Make sure that the fence height and angle locking levers 

are properly tightened. 

 

5. 

Install the power cord into the Plug-It receptacle on the 

6. 

Before you use the joiner, make sure to read the 

Some joints require the fence to be set to an angle from the 

mortising bit. The most common application is for making a 

mitered joint (see page 15).  

1. 

Unplug the joiner for safety. 

2. 

Loosen the fence angle locking lever by rotating it 

counterclockwise about ¼-turn. 

3. 

Rotate the fence face to the desired angle, and tighten 

the locking lever. 

► 

The fence has detent stops at 22½, 45, 67½, and 90 

degrees. 

► 

Use the gauge pointer for setting the fence to angles 

other than the ones listed above. 

► 

For greater stability, the locking lever clamps down on 

both right and left sides of the fence. 

 

 

60 30 

45 45 

36 54 

30 60 

25.7 64.3 

22.5 67.5 

Instruction Manual 

7