PSC 7000 사용자 설명서

Label ID

Character conversion is an eight byte configuration item.  The eight 
bytes are 4 character pairs represented in hexadecimal ASCII values.  The 
first character in the pair is the character that will be converted.  The sec-
ond character in the pair is the character to convert to.  If the character 
to convert in a pair is 

FF, then no conversion is done.

For example, if you have the character conversion configuration item set 
to the following:  

The first pair is 

4142 or AB (41 hex is an ASCII capital A, 42 hex is an 

ASCII capital B) and the second pair is 

3132 or 12 (31 hex is an ASCII 

1, 

32 is an ASCII 2).  The other two pairs are FFFF and FFFF.

With the label, AB12BA21, it would look as follows after the character 
conversion:  BB22BB22.

The A characters were converted to B characters and the 1 characters 
were converted to 2 characters.  Nothing is done with the last two char-
acter pairs, since they are all 

FF.

To set Character Conversion:

1. Scan the START bar code.

2. Scan the Character Conversion bar code.

3. Determine the desired string. Sixteen positions must be deter-

mined as in the above example. Next, turn to the 

 on 

the inside back cover of this manual and find the equivalent hex 
digits needed to fulfill the string.

4. Turn to 

 and scan the bar codes rep-

resenting the hex characters determined in the previous step. 

5. Scan the END bar code to exit Programming Mode.

Scan the END bar code to exit programming mode.