Fujitsu DL7400 사용자 설명서

 

Press the AUTO GAP button and the HI IMPACT button 

>> 

 

<< FUNCTION >> 
SAVE&END MENU1    MENU2    HARDWRE  ADJUST   CONFIG   GAP-ADJ  DEFAULT  LIST     SELF-TST  
HEX-DUMP V-ALMNT  INITIAL 

simultaneously until the printer beeps. Wait for the printer to 
stop printing and check that the following <<FUNCTION
menu is printed: 

 

position the cursor on the left edge of the aluminum print guide 
on DEFAULT. Press the S button or the T button to select the 

> 

. 

1 or MENU2. 

This

ollowing diagnostic functions: 

• 
• 
• V-ALM

These fu
printer p
program

rs

The SEL T
operates inde
the interface between the co

ns, 

. 

L24C PLUS emulation is selected for MENU1, the self-test is 

printed using the settings currently assigned to MENU1. 

Repeatedly press the “TEAR OFF” or “LOAD” button to 

DEFAULT function. The printer reprints the <<FUNCTION>
menu. The default values in MENU1 and MENU2 are now reset

•  Select new options for MENU
•  Exit setup mode, saving the factory defaults. 
See the section MENU1 and MENU2 Items and Options. To 
exit setup mode and save the new defaults, make sure that the 
cursor on the left edge of the aluminum print guide are 
positioned on SAVE & END, then press the S MICRO button 
or the T MICRO button. 

 section describes how to use the f

SELF-TST 

HEX-DUMP 

NT 

nctions are used for checking print quality and diagnosing 

roblems. HEX-DUMP also provides useful information for 

me . 

F- ST function prints test pages to check how the printer 

pendently of your computer. The self-test does not check 

mputer and the printer. 

The self-test prints the printer’s firmware version, its resident emulatio
and all of the characters available in the currently selected character set

If the DP