Fujitsu DL7400 사용자 설명서

6

 

Your printer requires very little care. Occasional 
cleaning and replacement of the ribbon cartridge 
are all that is required. 

Lubrication of the printer is usually not necessary. 

If the print head carriage does not move smoothly back and forth, clean 
the printer as described in this chapter. If the problem continues, contact 
your dealer to determine whether lubrication might be needed. 

 

The front cover, the rear stacker, and the paper table of the printer help 
protect against dust, dirt, and other contaminants. However, paper 
produces small particles that accumulate inside the printer. 
This section explains how to clean and vacuum the printer and how to 
clean the platen. 

It is easier to clean the printer when the front cover and the rear stacker 
are removed. 

 

 

Use the following procedure to clean and vacuum the printer as required: 

1.  Remove any paper from the printer. Make sure that the power is 

off, and then disconnect the printer power cord. 

2.  Using a soft vacuum brush, vacuum the exterior of the printer. 

Be sure to vacuum the air vents at the front, left sides, and 
bottom of the printer. Also vacuum the paper table, rear stacker, 
and the cut sheet feeder. 

3.  Use a soft, damp cloth to wipe the exterior of the printer, 

including the cover, paper table, and rear stacker. A mild 
detergent may be used.