Fujitsu DL7400 사용자 설명서
USING SETUP MODE
When you enter setup mode, the following <<FUNCTION>> menu is
OVERVIEW OF
SETUP MODE
SETUP MODE
printed:
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-TST
HEX-DUMP V-ALMNT INITIAL
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-TST
HEX-DUMP V-ALMNT INITIAL
Table 5.1 summarizes the purpose of each function.
Table 5.1 Setup Mode Functions
Function Purpose
SAVE & END
Exits setup mode and saves any changes made while
in setup mode.
in setup mode.
MENU1 and
MENU2
MENU2
Assigns print features to MENU1 and MENU2 on the
printer control panel.
printer control panel.
HARDWRE
Changes the printer hardware options.
ADJUST
Changes the print position adjustment options.
CONFIG
Changes the configuration options.
GAP-ADJ
Adjust the gap between the print head and printing
paper.
paper.
DEFAULT
Resets factory defaults in MENU1 and MENU2.
INITIAL
Resets factory defaults in MENU1, MENU2,
HARDWRE, ADJUST, CONFIG, GAP-ADJ.
HARDWRE, ADJUST, CONFIG, GAP-ADJ.
LIST
Prints a list of all currently selected options.
SELF-TST
Runs the self-test.
HEX-DUMP
Prints hex dumps.
V-ALMNT
Checks and corrects vertical print alignment.
To select a function from the <<FUNCTION>> menu:
1. Repeatedly press the “TEAR OFF” or “LOAD” button to
position the cursor on the left edge of the aluminum print guide
at the function you require.
at the function you require.
2. Press
the
S button or the T button to select the function. If the
function has items and options, the printer prints the first item
and its options. The MENU1, MENU2, HARDWRE, ADJUST,
CONFIG, and GAP-ADJ functions contain items that have
selectable options. The other functions have neither items nor
options.
and its options. The MENU1, MENU2, HARDWRE, ADJUST,
CONFIG, and GAP-ADJ functions contain items that have
selectable options. The other functions have neither items nor
options.
5-4
User's Manual