Ricoh 2015 사용자 설명서
Remote Maintenance by telnet
89
9
SMB
Use the “smb” command to configure
or delete the NetBEUI settings such as
the computer name or workgroup
name.
or delete the NetBEUI settings such as
the computer name or workgroup
name.
msh> smb parameter
Note
❒ You cannot use a computer name
starting with “RNP” or “rnp”.
ROUTE
Use the “route” command to control
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
Note
❒ The maximum number of routing
tables is 16.
*1
IP address
SLP
Use the “slp” command to configure
SLP settings.
You can search the NetWare server us-
ing SLP in the PureIP environment of
NetWare5/5.1, 6. Use the “slp” com-
mand to configure the value of TTL
used by the SLP multi-cast-packet.
SLP settings.
You can search the NetWare server us-
ing SLP in the PureIP environment of
NetWare5/5.1, 6. Use the “slp” com-
mand to configure the value of TTL
used by the SLP multi-cast-packet.
Note
❒ The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Parameter
Settings
comp
Your computer name consist-
ing of up to 15 characters
ing of up to 15 characters
group
Workgroup name consisting
of up to 15 characters
of up to 15 characters
comment
Comment consisting of up to
31 characters
31 characters
notif {on |
off}
off}
You can enable or disable no-
tification of print job comple-
tion.
tification of print job comple-
tion.
clear comp
Clears the computer name
clear group
Clears the Workgroup name
clear com-
ment
ment
Clears comment
Commands Topics of setting
gateway
Adds a host/network route
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
Deletes a host/network route
from the table. Host becomes
the default.
from the table. Host becomes
the default.
}
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
destination on or off. Host be-
comes the default.
You can set the default gate-
way address.
way address.
route flush
Deletes all routing informa-
tion.
tion.