Ricoh Type 3260 사용자 설명서
Troubleshooting
141
8
Exceeded max. stored files in
sample print and locked
print.
sample print and locked
print.
The maximum number of
stored files has been exceeded
during Sample Print or
Locked Print.
stored files has been exceeded
during Sample Print or
Locked Print.
Delete some stored files or re-
duce file sizes.
duce file sizes.
Exceeded max. stored pages
in sample print and locked
print.
in sample print and locked
print.
The maximum number of
stored pages has been exceed-
ed during Sample Print or
Locked Print.
stored pages has been exceed-
ed during Sample Print or
Locked Print.
Reduce the number of pages
to be printed.
to be printed.
File system error. Cannot
print PDF file(s).
print PDF file(s).
The PDF file cannot be printed
due to file system error.
due to file system error.
Check the PDF file for errors.
HDD is full.
The maximum hard disk area
size for form/font has been ex-
ceeded.
size for form/font has been ex-
ceeded.
Delete unused form / font
types.
types.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
curred during Sample Print or
Locked Print.
Delete some stored files, or re-
duce the size of the file to be
downloaded.
duce the size of the file to be
downloaded.
HDD has a problem.
An error has occurred in the
hard disk drive.
hard disk drive.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
IEEE 802.11b (Wireless LAN)
has a problem.
has a problem.
IEEE 802.11b interface unit
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
Turn off the machine and
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
Output tray has been
changed.
changed.
The output tray has been
changed because of the paper
size limitation of the selected
tray.
changed because of the paper
size limitation of the selected
tray.
Select the correct output tray.
Paper in staple tray. Open
Finisher Cover and remove
paper.
Finisher Cover and remove
paper.
There is paper remaining in-
side the finisher.
side the finisher.
Open the cover of the finisher,
and remove the paper.
and remove the paper.
Paper type of XXX is mis-
matched.
matched.
Select another tray from fol-
lowings and press [Continue].
To cancel job, press [Reset].
Paper type can also be
changed in User Tools.
lowings and press [Continue].
To cancel job, press [Reset].
Paper type can also be
changed in User Tools.
Type and thickness of the pa-
per to be printed on differ
from the machine's paper set-
tings.
per to be printed on differ
from the machine's paper set-
tings.
Set paper type and thickness
using [Tray Paper Settings] in
System Settings. For details,
see General Settings Guide.
using [Tray Paper Settings] in
System Settings. For details,
see General Settings Guide.
Messages/Second messages
Causes
Solutions
VenusC1GB-Printer-F8_FM.book Page 141 Tuesday, March 29, 2005 4:51 PM